[User Guide] Anderic 99770 Ceiling Fan Remote Control

Please make a note of the following information:

The Anderic 99770 Ceiling Fan Remote Control seamlessly replaces models 99813, 99770, 99732, 99392, KB286, K6132, K6266, K6019, and K5579, ensuring broad compatibility with your existing setup. For optimal performance, ensure your original remote matches one of these models, as this remote is not recommended for other models.


This remote control requires a pre-installed receiver, as the receiver is not included with this replacement unit. This manual does not include instructions for installing the receiver.

Pairing

  1. Turn off the power to the ceiling fan using the wall switch or breaker
  2. Open the battery compartment.
  • To access the battery compartment, remove the screw (if inserted) and slide the battery door downwards.
  1. Install the batteries.
  • Install a CR2032 battery into the remote control with the positive side facing up. Reinstall the battery door.
  1. Turn the power on to the fan.
  2. Within three minutes, press the pair button located in the battery compartment. If pairing was successful, a single beep will sound. Replace the battery door.

Button functions

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.