[User Guide] Anderic RR399A for Sealy RF399A Adjustable Bed Remote Control

This article applies to the Anderic RR399A Adjustable Bed Remote Control.

Note: This remote only works with Sealy Ease 2.0, Sealy Ease 3.0, and Sealy Ease 4.0 adjustable bed frame models.

Installing Batteries

1. Open the battery cover by sliding off the back panel downward towards the bottom of the remote. 
2. Install three (3) AAA-sized batteries into the remote, matching polarity. 

Pairing Instructions For Ease 2.0

1. Locate the Battery backup box under the bed and press the button TWICE. (Light will illuminate) 
2. Remove the cover from the back of the remote to expose the PAIR button.
3. Press and hold the pair button for 3 seconds. (The button will flash TWICE) The control box light will turn off upon successful pairing. 
4. Release the PAIR button and test all remote functions to ensure everything works correctly.

Pairing Instructions for Sealy Ease 3.0 and 4.0

1. Unplug the base power cord from the outlet, wait for 20 seconds, and then plug it back in. (The receiver box light under the bed will start to flash.) 
2. Remove the cover from the back of the remote to expose the PAIR button. Press and hold the pair button inside the battery compartment for 3 seconds. (The button will flash TWICE) and the control box light will turn solid with a successful pair. Please note that you must complete step 2 within ten seconds, or the receiver box will stop flashing. 
3. Release the PAIR button and test all remote functions to ensure everything works correctly.

Remote Functions

Adjustments:

Head Position Adjustments (A, B) 

• Use to raise and lower the head section of your adjustable base. 

Foot Position Adjustments (C, D) 

• Use to raise and lower the foot section of your adjustable base. 

Bed FLAT Button (E) 

• Press down and hold for three (3) seconds to return the bed to a flat position. 

Zero Gravity (F) 

• Use this to adjust your legs to relieve pressure on the lower back. 

NOTE: For optimal performance, please return the bed to its flat position before selecting the Zero Gravity preset.

Activate Child Lock

1. Press and hold the HEAD UP and

   ZERO-G buttons together for 3 seconds. 

2. The remote LED backlight will flash. When it stops flashing, the remote is now in Child Lock—pressing any buttons while in Child Lock will yield no movement to your adjustable base.

Deactivate Child Lock

1. Press and hold the HEAD DOWN and ZERO-G buttons together for 3 seconds. 
2. Press and hold the HEAD UP & ZERO-G buttons together for 3 seconds. 
3. The remote LED backlight will flash. When it stops flashing, the remote is no longer in Child Lock. The remote and adjustable base will work normally.