[User Guide] Anderic RRAV498 for Yamaha AV Receiver Remote Control

Programming

• Pre-programmed for Yamaha receivers—no setup required.

• Designed as a direct replacement for the original Yamaha RAV498 remote.

• Includes an instruction manual for easy use.

• Can be programmed to control other devices such as TVs, DVD players, and satellite receivers.

• Guaranteed compatibility with select Yamaha receivers (refer to the “Used with Models” section for details).

Refer to the code list section of your user manual to find the corresponding code for the device brand you wish to register.
- Register the first code in the list if there are multiple remote control codes. If that does not work, try the other codes.
Press the [CODE SET] key using a pointed object, such as the tip of a ballpoint pen.
- SOURCE/RECEIVER blinks twice.
- Perform each of the following steps within one minute. Otherwise, the setting will be canceled. If this happens, repeat from step two.
Press the input selection key.
- For example, press the HDMI 1 button to set the remote control code for the playback device connected to the HDMI 1 jack. 4.
- Use the numeric keys to enter the 4-digit remote control code.
- Once the remote control code is registered successfully, the SOURCE/RECEIVER blinks twice.
- If it blinks six times, registration has failed. Repeat Step Two.

You can reset the remote control code registered to each input selection key.
Press the [CODE SET] key using a pointed object, such as the tip of a ballpoint pen.

SOURCE/RECEIVER Blinks twice
Perform each of the following steps within one minute. Otherwise, the setting will be canceled. If this happens, repeat from step one.

Press the input selection key you wish to reset.
Use the numeric keys to enter “5098”. Once the remote control code is reset successfully, the SOURCE/RECEIVER blinks twice. If it blinks six times, resetting has failed. Repeat from step one.

Press the [CODE SET] key using a pointed object, such as the tip of a ballpoint pen.
Press SOURCE/RECEIVER.
Use the numeric keypad to enter “9981”.