[User Guide] Anderic RRTR292A Ceiling Fan Remote Control

This article applies to Anderic and Harbor Breeze Ceiling Remote Controls with identification numbers: RRTR292A, KUJCE10612, TR292A, TRD050G1M, 2AQZU18053

Learning Process

NOTE: The Hand-Held Remote Control System is equipped with a learning frequency function

which has code combinations to prevent potential interference from other remote units

Open the remote battery cover and install DC3V and AAA 2-piece batteries.
Within 30 seconds of turning the receiver's AC power ON.
Press and hold the remote's “LEARN” key for over 5 seconds. Once the receiver has detected the frequency, it will make a sound, “Bi Bi,” twice. This indicates that the receiver has learned the previously selected frequency from the transmitter.

NOTE: After the AC power is on, do not press any other button on the transmitter before setting the learning mode. Doing so will cause the procedure to fail. After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the transmitter, please turn off the receiver's power. And repeat steps 1 and 2.

NOTE: Remove the battery from the handheld remote if it is not in use for extended periods to prevent damage.

Functions of The Remote

[Power] To turn the fan on or off.
[+] Press this button to increase the fan speed, and the LED indicator will be on the position of the fan speed. (1~6 speed)
[-] Press this button to decrease the fan speed, and the LED indicator will be on the position of the fan speed. (1~6 speed)
FANTIMER:
[2hr]: Setting up the ceiling fan to turn off automatically after 2 hours.
[4hr]: Setting up the ceiling fan to turn off automatically after 4 hours.
[8hr]: Setting up the ceiling fan to turn off automatically after 8 hours. Press the fan speed button to deactivate
[Person] Tap once to activate. The light on the ceiling fan blinks once to confirm that the Walk Away Delay is active. The light turns off after 1 minute. Press any key to cancel the function.
[Home] HomeShield: Press and hold the button to activate. The light on the ceiling fan blinks twice to confirm that Home Shield is active. The fan remains off, and the light randomly turns on for a duration of between 5 and 20 minutes. The light stays off for 60 minutes between events. To deactivate, press any button once.
[≋] Press the button to set the fan speed to change automatically. Press Fan Speed to deactivate.
[Light Bulb]: Press to turn on and turn off the light

NOTE: The LED indicator should be in position one when pressing the remote button. If you press the remote button and the LED indicator is not on, replace the batteries.