[User Guide] Anderic RRTR214D Ceiling Fan Remote Control for Harbor Breeze TR214D - Mazon and others

Compatibility

Introducing the Anderic RRTR214D (TR214D) Ceiling Fan Remote Control, the ideal replacement for your Harbor Breeze remote controls. This remote seamlessly replaces models such as A25-FA0138, KUJCE10311, TR214B, KUJCE10712, TR214A, and KUJCE10610, ensuring compatibility with your existing ceiling fan receiver. 

Note: You must already have the receiver installed; this manual does not guide you through the receiver installation. For help installing the Mazon Ceiling fan receiver, please refer to this link.

WARNING: Two remotes cannot be paired to the same fan. After a successful pairing, any previously paired remotes will no longer be paired. If possible, if you have other remotes already paired to the same fan, please remove the battery before proceeding, as they will cause interference with the pairing process.

Pairing with your fan

  1. Remove the power from the ceiling fan by either flipping the wall switch or powering the breaker off.
  2. Remove the battery cover from the back of the remote control. 
  3. Install one 12-volt A23 Battery, being sure to match polarities, which are marked with the (+) and (-).
  4. Restore power to the fan and within 30 seconds, press and hold the "0" key for 5 seconds or until the light on the fan blinks twice. Use the remote control transmitter to test the light and fan functions to confirm the learning process is complete.  

Operating the remote

  • 3 button - for fan speed HIGH
  • 2 button - for fan speed MEDIUM
  • 1 button - for fan speed LOW
  • 0 button - to turn fan OFF
  • 💡 button - to turn the light ON or OFF
  • Tap the 💡 button quickly to turn the lights off or on. Hold the 💡 button down to increase or decrease lights. If you press the 💡 button in excess of 0.7 seconds, it becomes a dimmer. The lights vary cyclically in 8 seconds. The light button has an auto resume function, which keeps the light at the same brightness as the last time it was turned off. 

CAUTION: The remote control transmitter can be programmed to multiple receivers or fans. If this is not desired, turn wall switch off to any other programmable receiver or fan.


FCC Compliance Notice for Remote Control

Modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment.


*NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • * Reorient or relocate the receiving antenna.
  • * Increase the separation between the equipment and receiver.
  • * Connect the equipment to an outlet on a circuit different from that to which

    the receiver is connected.

    Consult a dealer or an experienced radio or TV technician for assistance. 

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us