[User Guide] Anderic FAN35T Ceiling Fan Remote Control
This article applies to the Anderic FAN35T Ceiling Fan Remote Control.
- View this article for installation and pairing instructions for the FAN30R Receiver
- View this article for pairing with receivers that have 4-dip switches
Table of contents
Information
- Install a 23A,12-volt battery. (To prevent damage to the transmitter, remove the battery if not used for a long time.)
- Store the transmitter away from excessive heat or humidity.
- This remote control unit features 16 distinct code combinations. To prevent possible interference with or from other remote units, such as garage door openers, car alarms, or security systems. If your fan and light kit go on and off without using your remote control, change the code combination in your transmitter.
Basic Button Functions
Operating the buttons on the panel of the transmitter.
- [III] key for fan high speed.
- [II] key for fan medium speed.
- [I] key for fan low speed.
- [O] key for fan off.
- [LIGHT] key for light brightness.
Dimming and Light Functions
The light function is controlled by pressing the [LIGHT] key down to increase or decrease the light. Tap the key quickly to turn the light off or on. Press the button for over 0.7 seconds, and it becomes a dimmer; the light varies cyclically every 0.8 seconds. The receiver can remember the last status of the light brightness when the light is switched, so that it can resume adjusting the light brightness.
